Setting The I/O Control Options - Epson Equity 4 Setup Manual

Setting the l/O Control Options
The I/O control options let you change the settings for the
following built-in interface ports:
You may need to change these settings if you install an
interface on an option card. The following table lists the
possible settings.
I/O
control options
I/O control option
COM1 Select
COM2 Select
Parallel Port
Address
Setting
Enabled*
Disabled
Enabled*
Disabled
O3BCH
Disabled
Running the SETUP Program
I Enables the COM 1 serial port
I Disables the COM 1 serial part
Enables the COM2 serial part
Disables the COM2 serial part
Sets the parallel part address to
03BCH
I Disables the parallel port
2-19