If you install one type of display adapter card and then change
the adapter (from VGA to CGA or vice-versa), you also may
need to set jumper J5. If you have two types of cards, set the
jumper to match the adapter controlling your primary display.
See Chapter 2 in the User's Guide for instructions on changing
jumper settings and the manual that came with your monitor
for additional information.
Setting the Self Test Error Level
When you start your system, it performs a self test. The
H a l t on option determines the point at which the system will
stop if it finds an error during the self test.
If your computer is running without a keyboard or diskette
drive or it must always start, you can choose one of the options
in the following table to ensure the computer will boot.
Self
error levels
test
Default setting
2-6
Running the SETUP Program
It
You want your system to stop booting if it encounters
any errors during the self test
You don't want your system to stop booting, even If it
encounters errors during the self test
You want your system to stop booting if it encounters
any error except a keyboard error during self test
You want your system to stop booting if it encounters
any error except a diskette drive error during self test
You want your system to stop booting if it encounters
any error except either a diskette drive error or a
keyboard error during self test