Epson Equity 4 Setup Manual page 26

Chapter 2
The first time you use your computer, you need to run the
SETUP program to define how your system is set up. You may
need to run it again later if you change your configuration.
The SETUP program is stored in the computer's read-only
memory (ROM), so you can run it any time you turn on or reset
your computer. SETUP lets you verify or change the following:
Current date and time
Type of diskette drive(s) installed
Type of video display adapter you are using
Self test error level
Cache
Shadow RAM and additional extended memory usage
Password feature
Type of hard disk drive(s) installed
System memory
System booting sequence
virus warning
Bus control options
I/O control options.
Running the SETUP Program 2-1