Dell SmartStep 200N Replacement Manual page 82

HINT: After installing
the system board, enter
the computer service tag
sequence into the BIOS of
the replacement system
board.
82 Sy stem Boar d
Press down on the system board while using the plastic scribe to pry
3
away the left side of the bottom case near the audio connectors. The
system board snaps into place in the bottom case.
Replace the system board screws and rubber bumper.
4
Connect the speaker cable.
5
Replace the video shield.
6
Replace the microprocessor
7
assembly that you removed from the old system board.
Replace the charger board.
8
NOTICE: Route cables so that they will not be crimped or pinched when the
complete assembly is put back together.
Replace the video shield that you removed from the old system board.
9
Replace the display assembly
10
Replace the floppy
11
module, and hard drive.
If applicable, replace the PC Card or blanks in the PC Card slot.
12
NOTICE: Before turning on the computer, replace all screws and ensure that
no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
If applicable, replace the battery.
13
Insert the CD that accompanied the replacement system board into
14
the appropriate drive, and turn on the computer. Follow the
instructions on the screen.
and the microprocessor thermal-cooling
and the keyboard.
drive, palm rest, optical drive, modem, memory