Eagle IntelliMap 500C Installation And Operation Instructions Manual page 68

1.
1.
Route creation sequence, from left: Fig. 1. Set route waypoint (1) at the
cove entrance. Fig. 2. Move cursor northeast to set point (2) at channel
entrance. Fig. 3. With point (2) set, move cursor southeast to mark
channel exit with waypoint (3). In figures 2 and 3, notice the rubber
band line extending from the previously set waypoint to the cursor.
This line will become the course for the route.
4.
Route creation sequence, continued: Fig. 4. Point (3) set at channel
mouth. Fig. 5. Waypoint (4) set further south along the beach, at a rec-
ognizable landmark (Bob Hall Pier). Waypoint PLFM Q W ends the
route at an oil platform some distance from the shore. Fig. 6. Press EXIT
to save the route and you return to this screen.
6. Move the cursor to the next point in the route, a spot where you need
to turn or change direction, and press
7. Repeat step six until the route reaches your destination.
2.
2.
5.
to set the next waypoint.
ENT
62
3.
3.
6.