Table of Contents
Advertisement
Adjusting Screen Brightness
This feature configures the LCD Brightness levels.
1. Press
Brightness.
2. Tap Automatic brightness to allow the phone to self-
adjust and tap OK.
– or –
Touch and slide the on-screen slider to adjust the level
and tap OK.
Gyro Sensor Calibration
Calibrate your phone by using the built-in gyroscope.
1. Press
Gyroscope calibration.
2. Place the phone on a level surface and tap Calibrate.
The phone adjusts the level of the accelerometer.
During the calibration process a green circle appears
on-screen and the center circle adjusts to the center
position.
and then tap Settings
Display
and then tap Settings
Display
Power Saving Mode
This feature allows you both automatically set the phone to
use a power saving mode and configure additional power
saving options manually, all in an effort to conserve battery
power.
1. Press
saving.
2. Select System power saving to use the device's default
power saving parameters.
– or –
Select Custom power saving to create your own custom
power saving plan. Once enabled, you can adjust the
settings.
3. When the power gets low, confirm
top of the screen. This indicates the power saving
mode is active.
To automatically enable power saving from Notifications:
1.
In a single motion, touch and drag the Status bar down to
the bottom of the screen to reveal the Notifications panel
2. Tap Power Saving. For more information, refer to
"Notification Panel" on page 40.
and then tap Settings
Power
appears at the
Changing Your Settings
.
268
Advertisement
Table of Contents
