Sonar Simulator; Stop Chart - Eagle Cuda 250i S/Map Installation And Operation Instructions Manual

Sonar Simulator

This unit has a built-in simulator that will allow you to practice as
though you were on the water. All sonar features and functions will be
useable during a simulation. When in simulator mode, you will see
[Simulator Mode] in the Sonar Page title bar. To use the simulator:
1. From the Sonar Page, press
2. Select
S
ONAR
position, highlight
the GPS Simulator.
NOTE:
If you turn on your unit before attaching a transducer, it may enter
a demo mode. The words demo mode flash on the bottom of the
screen and a sonar chart will play. Unlike the simulator, the demo
mode is for demonstration only and will automatically stop as soon
as you turn on the unit with a transducer attached. The simulator
will continue to function normally.

Stop Chart

If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar and
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
Press |↓ to
MENU
To turn the sonar on again, repeat the step above.
and press
S O
IMULATOR N
S P
IMULATE
|
S C
TOP HART
|
MENU MENU
. If you want to simulate your
ENT
and press
OSITION
| .
ENT EXIT
79
|↓ to
S S
ONAR ETUP
, which will turn on
ENT
| .
ENT