Sonar Simulator; Stop Chart - Eagle 480 Installation And Operation Instructions Manual

Data Type and pressing Enter, use the ↓ key to select another
window to change. When the selected window title bar flashes,
press
ENT
you're finished customizing, then press
Page.

Sonar Simulator

This unit has a built-in simulator that lets you run it as if you were on
the water. All sonar features and functions are useable. When in
simulator mode, you will see [Simulator Mode] in the Sonar Page title
bar. To use the simulator:
1. From the Sonar Page, press
2. Turn off Sonar Simulator by pressing
|
S ENT
IMULATOR
NOTE:
If you turn on your unit before attaching a transducer, it may enter
a demo mode. The words "demo mode" flash on the bottom of the
screen and a sonar chart plays much like the simulator. Unlike the
simulator, the demo mode is for demonstration only, and will
automatically stop as soon as you turn on the unit with a
transducer attached. The simulator will continue to function
normally.

Stop Chart

If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar and
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
1. Press
MENU
To turn on sonar and start the chart scrolling again, repeat the above step.
|↑ or ↓ to select data type|
| .
EXIT
|↓ to
S C
TOP HART
ENT
| |↓ to
MENU MENU
| | .
ENT EXIT
74
. Repeat these steps until
to return to the Sonar
EXIT
S S
ONAR IMULATOR
|
MENU MENU
| .
ENT
|↓ to
S
ONAR