Assembling The Pump Body - Philips SCF302/01 User Manual

Assembling the Pump Body

Before assembling, make sure that your hands are clean and you have correctly washed and
sanitized the pump (see 'Cleaning and Sanitizing Your Pump' on page 7). Also check that none
of the pump components are damaged.
Parts you will need for steps 1-4:
Pump body
Let-down Massage Cushion
9 Need Help? Call us at 1.800.54.AVENT or visit www.philips.com/AVENT
White valve Silicone diaphragm with stem
Milk container White stand
Insert the white valve into the pump
1
body, so that it fits securely into the
small round hole. Make sure the pointed
side of the valve is facing down.
Fit the clear silicone diaphragm with stem into
2
the pump body. Ensure a perfect seal around the
rim by pressing down with your fingers. (This is
easier if assembled while the diaphragm is wet.)
Screw the pump body onto the milk
3
container until securely in place.
To ensure that the pump is completely
stable, you can use the stand with the
4oz/125ml milk container.
Insert the Let-down Massage Cushion and
4
secure the rim around the funnel making sure
there are no gaps. Run your thumb on the flat
surface between each petal to ensure there are
no air pockets. (This is easier if assembled while
the Let-down Massage Cushion is wet.)
HELPFUL TIP!
Some women may prefer to use the pump without the
Let-down Massage Cushion.The Let-down Massage
Cushion has petals that flex in and out to gently massage
the area around the areola.This is intended to help
stimulate a fast, natural milk flow.When using the breast
pump without the Let-down Massage Cushion, the
maximum vacuum level achievable will be higher.
Assembling the Pump Body
10