Safety Instructions; Warnings And Precautions - Philips BDL4245E/27 User Manual

BDL3245E / BDL4245E / BDL4645E

Safety Instructions

Warnings and Precautions

CAUTION:
T O REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product.
This symbol alerts you that important literature concerning operation and maintenance has been included with this product.
Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section
54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
CAUTION: F CC/CSA regulations state that any unauthorized changes or modifications to this equipment may void the user's authority to operate it.
CAUTION: T o prevent electric shock, match the wide blade of plug to the wide slot, and fully insert the plug.
IMPORTANT: O ne Federal Court has held that unauthorized recording of copyrighted TV programs is an infringement of U.S. copyright laws. Certain
Canadian programs may also be copyrighted and any unauthorized recording in whole or in part may be in violation of these rights.
TO PREVENT DAMAGE WHICH MAY RESULT IN FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
The Socket-outlet shall be installed near the apparatus and shall be easily accessible.
Read and follow these instructions when connecting and using your computer monitor:
• Unplug the monitor if you are not going to use it for an extensive period of time.
• Unplug the monitor if you need to clean it with a slightly damp cloth. The screen many be wiped with a dry cloth when the power is
off. However, never use alcohol, solvents or ammonia-based liquids.
• Consult a service technician if the monitor does not operate normally when you have followed the instructions in this manual.
• The casing cover should be opened only by qualified service personnel.
• Keep the monitor out of direct sunlight and away from stoves or any other heat source.
• Remove any object that could fall into the vents or prevent proper cooling of the monitor's electronics.
• Do not block the ventilation holes on the cabinet.
• Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture.
• If turning off the monitor by detaching power cable or DC power cord, wait for 6 seconds before attach the power cable or DC
power cord for normal operation.
• To avoid the risk of shock or permanent damage to the set do not expose the monitor to rain or excessive moisture.
• When positioning the monitor, make sure the power plug and outlet are easily accessible.
• IMPORTANT: Always activate a screen saver program during your application. If a still image in high contrast remains on the
screen for an extended period of time, it may leave an 'after-image' or 'ghost image' on the front of the screen. This is a well-known
phenomenon that is caused by the shortcomings inherent in the LCD technology. In most cases the afterimage will disappear
gradually over a period of time after the power has been switched off. Be aware that the after-image symptom cannot be repaired
and is not covered under warranty.
KNOW THESE SAFETY SYMBOLS
ii