Contents 1 Important Safety 2 Your Docking Speaker Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Prepare the remote control Connect power Turn on 4 Play Play from iPod/iPhone/iPad Play from Bluetooth devices Play from an external audio device Adjust volume Mute sound...
1 Important h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being Safety walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Philips offers, register your product at www.philips.com/welcome. Warning If you contact Philips, you will be asked for the model and serial number of this apparatus. The • Keep the battery away from heat, sunshine or fire. Never discard battery in fire. model number and serial number are on the •...
Overview of the main unit a Dock for the iPod/iPhone/iPad d Power supply socket • Connect AC power. • Adjust volume. • As LED indicators, show system status. • Sync with PC through a USB cable. f MP3-LINK • Select Bluetooth mode. • Connect an external audio device.
3 Get started Overview of the remote control Always follow the instructions in this chapter in sequence. Prepare the remote control For first-time use: Remove the protective tab to activate the remote control battery. To replace the exhausted battery: Open the battery tray. Insert one CR2025 battery with correct polarity (+/-) as indicated.
Listen to the iPod/iPhone/iPad • In standby mode, if you press on the main unit or Philips DockStudio app brings a suite of new on the remote control, the docking speaker switches features to your docking speaker. To enjoy more to the corresponding selected source.
• To pause or resume play, press • To skip to a track, press • To search during play, press and hold then release to resume normal play. Update firmware If firmware update is available, the DockStudio app will search for it automatically and ask you to download it.
Follow the on-screen instructions to Sync iPod/iPhone/iPad with PC complete the firmware update. Note • Make sure that iTunes has been configured properly in your PC. Insert the iPod/iPhone/iPad in the dock. Press and hold for 2 seconds to switch the docking speaker to standby mode. » The LED indicators light off. Connect your docking speaker and PC with a USB cable.
You can select MP3 link source by pressing on the remote control. Scan Bluetooth devices that can pair with your device. When “PHILIPS DS3600” is displayed on Adjust volume your device, select it to start connection. » Double beep tone confirmation can be To adjust volume: heard and the Bluetooth indicator light Press +/- on your docking speaker;...
Philips Web page (www.philips.com/support). When you contact Rated Output Power 2 X 10 W RMS Philips, make sure that the device is nearby Signal to Noise Ratio > 57 dBA and the model number and serial number are...
Bluetooth connection. device that are not expressly approved by • The device cannot be used with the Philips Consumer Lifestyle may void the user’s system to play music. authority to operate the equipment. The audio quality is poor after connection with a Bluetooth-enabled device.
• Consult the dealer or an experienced Please visit www recycle.philips.com for radio/TV technician for help. additional information on a recycling center in This equipment complies with FCC’s and IC's your area. RF radiation exposure limits set forth for an Environmental information uncontrolled environment.
Page 14
R n , o reg p l p Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below,so don't miss out. ensur Register online at www.philips.com/welcome to ensure: *Product Safety Notification...
Page 15
ANY EXPRESS OR IMPLIED WARRANTY ON THIS PROD- UCT. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE Philips is not liable for any damage to or loss of any programs, LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR data, or other information stored on any media contained within...