Contents 1 Important 2 Your Docking Speaker Introduction What’s in the box Overview of the main unit Overview of the remote control 3 Get started Prepare the remote control Connect power Turn on 4 Play Play from iPod/iPhone/iPad Play from Bluetooth devices Play from an external audio device Adjust volume Mute sound...
1 Important • The USB socket is for data transmission only. • Where the plug of the Direct Plug-in Adapter is used as the disconnect device, • Read these instructions. the disconnect device shall remain readily • Heed all warnings. operable.
Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No.
Overview of the main unit a Dock for the iPod/iPhone/iPad d Power supply socket • Connect AC power. • Adjust volume. • As LED indicators, show system status. • Sync with PC through a USB cable. f MP3-LINK • Select Bluetooth mode. • Connect an external audio device.
3 Get started Overview of the remote control Always follow the instructions in this chapter in sequence. Prepare the remote control For first-time use: Remove the protective tab to activate the remote control battery. To replace the exhausted battery: Open the battery tray. Insert one CR2025 battery with correct polarity (+/-) as indicated.
Press and hold for 2 seconds again; or • The system is idle for 15 minutes. Philips DockStudio app brings a suite of new » In standby mode, the LED indicators light features to your docking speaker. To enjoy more off.
Page 8
For first-time use, you will be asked to If a new firmware update is found, tap OK. install DockStudio app on your iPod/ iPhone/iPad. Tap [Yes] (yes) to accept the installation request. Follow the on-screen instructions to complete the installation. Launch the app after the installation. Follow the on-screen instructions to Play audio on your iPod/iPhone/iPad. complete the firmware update.
Launch iTunes to synchronize your docking speaker with PC. » The docked iPod/iPhone/iPad is synchronized with PC successfully through the iTunes. Note • Due to different materials and product techniques, some USB cables may not work with this device. Play from Bluetooth devices Note •...
» Music comes through the docking iPhone/iPad, Bluetooth device, or other speaker. external device. Mute sound • If your Bluetooth device has been paired with DS3600 before, you just need to find out “PHILIPS DS3600” on During play, press to mute or unmute sound. your Bluetooth menu, then confirm the connection. To disconnect Bluetooth: •...
Rated Output Power 2 X 10 W RMS requesting service. If the problem remains Signal to Noise Ratio > 62 dBA unsolved, go to the Philips web site Aux-in Link 500mV RMS (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are Bluetooth available.
Bluetooth connection. device that are not expressly approved by • The device cannot be used with the Philips Consumer Lifestyle may void the user’s system to play music. authority to operate the equipment. The audio quality is poor after connection with a Bluetooth-enabled device.
Page 13
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste.