Epson XP-300 Quick Manual page 20

5. Before you open the new
cartridge package, shake it gently
four or five times. Then remove
the cartridge from the package.
Caution: Do not touch the
green chip or the small window
on the side of the cartridge.
This can damage the ink cartridge.
6. Remove the yellow tape from the side of the ink
cartridge.
Caution: Do not remove any other labels or seals, or
ink may leak.
7. Insert the new ink cartridge into the holder and push
it down until it clicks into place.
8. Lower the scanner unit.
9. Press
OK
4 minutes. When you see a completion message on
the LCD screen, ink charging is finished.
Caution: Never turn off the your EPSON printer
while ink is charging or you'll waste ink. If you see
an ink replacement message on the LCD screen,
press OK and press down all the cartridges
securely. Then press OK again.
Note: If you replaced a cartridge while copying a
document or photo, cancel printing and make sure your original is still placed
correctly on the document table. Then copy your original again.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
20
Replacing Ink Cartridges
to begin charging the ink. This takes about