Electrical Requirements - Electrolux EHH3920BOK User Manual

• If the fixing bracket is near to the termi-
nal block, do not let the connection ca-
ble come in contact with the edge of
the bracket.
8.2 Electrical connection
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug (if applicable).
• The appliance must not be connected
with an extension cable, an adapter or
a multiple socket. There is a risk of fire.
• Do not let the power cable to heat up
to a temperature of more than 90° C.
The cable should be guided by means
of clamps fixed to the side of the cabi-
net, in order to avoid any contact with
the equipment beneath the cooktop.
• Make sure that there is access to the
mains plug after the installation.

Electrical Requirements

Permanent electrical installation must
agree with the latest I.E.E. Regulations
and local Electricity Board regulations. For
your own safety the installation must be
done by a qualified electrician (e.g. your
local Electricity Board, or a contractor
who is on the roll of the National Inspec-
tion Council for Electrical Installation Con-
tracting [NICEIC]).
The manufacturer refuses to be
held responsible, if these safety
measures are not abided by.
Supply connections:
This hob has to be connected to 230 —
240 V ( 50 Hz) electricity supply.
Before carrying out the connection, make
sure:
1. The limiter valve and the electrical
system can take the appliance load
(see the rating plate)
2. The supply system is equipped with
an efficient earth connection in com-
pliance with the current standards
and regulations
3.
The outlet or omnipolar switch used
for connection is easily accessible
with the appliance installed.
The appliance is supplied with a 3 core
flexible power cable.
The manufacturer refuses to be
held responsible, if these safety
measures are not abided by.
The wires in the cord are coloured as fol-
lows:
Green and yellow
Blue
Brown
Replacement of the connection cable
1. Connect the green and yellow (earth)
wire to the terminal which is marked
with the letter 'E', or the earth symbol
, or coloured green and yellow.
2. Connect the blue (neutral) wire to the
terminal which is marked with the let-
ter 'N' or coloured blue.
3. Connect the brown (live) wire to the
terminal which is marked with the let-
ter 'L' and is always connected to the
network phase.
There must be no cut or stray strands of
wire present. The cord clamp must be
correctly attached to the outer sheath.
To replace the connection cable
use only H05V2V2-F T90 or
equivalent type. Make sure that
the cable section is applicable to
the voltage load and the working
temperature. The yellow/green
earth wire (B) must be approxi-
mately 2 cm longer than the live
and neutral wire (A).
The replacement of electric cable
must be carried out exclusively by
the service force centre or by per-
sonnel with similar competencies,
in accordance with the current
regulations.
ENGLISH 33
- Earth
- Neutral
- Live
A B