Canon REALiS WUX10 Mark II D User Manual page 14

CHAPTER 2 • Routine Operation
2
Enter a projector group name, and place a check mark beside necessary
projector parameter categories and enter its conditions for classification.
It will be a "Status group" if more than one condition is specified, and a "User group" if
none is specified.
Projector group
name
Product name
Projector name
Location
Status
Warning
Lamp
Lamp Time
(converted)
Filter
Air filter time
3
Click [OK] when you have completed entering the conditions.
Projector group is now added in the Projector group list.
C4
Category
Enter a name within 40 one-byte characters.
E n t e r a p r o d u c t n a m e o f t h e p r o j e c t o r u s i n g o n e - b y t e
alphanumerical characters.
Enter any name of a projector in two-byte or one-byte characters.
Enter a location of the projector in two-byte or one-byte characters
Select a status of the projector from "Disconnected", "Power off",
or "Power on".
Select a warning status of the projector from "Yes" or "No".
Select a status of the lamp from "Normal", "Obtain a new lamp",
"Replace with the new lamp", "Obtain or replace with the new
lamp", or "Warning".
Select from "over" or "less than", and enter a number from 0 to
99999 for lamp usage time.
Select a status of the filter from "Normal", "Cleaning the air filter",
"Replacing the air filter" or "Cleaning or replacing the air filter".
Select from "over" or "less than" and enter a number from 0 to
99999 for air filter usage time.
Description