Canon Wireless File Transmitter WFT-E2 II A Instruction Manual page 17

[Enter connection] and [Search again]
To configure settings for the wireless LAN device manually, select [Enter connection] and
press <0>. Complete the settings for the items displayed, one after another.
To search for wireless LAN devices again, select [Search again] and press <0>.
Entering the Wireless LAN Encryption Key
Next, enter the encryption key of the wireless LAN device. For details on the encryption key,
refer to the device's instruction manual.
Note that the screens displayed in steps 1 to 3 below vary depending on the authentication and
encryption of the wireless LAN device.
The [Key index] screen is displayed only if WEP
1
encryption is used by the wireless LAN device.
Turn the <5> dial to select the key index number
specified as the access point, and then press
<0>.
Select [OK] and press <0> to go to the next
screen.
Turn the <5> dial to select the key format, and
2
then press <0>.
Select [OK] and press <0> to go to the next
screen.
Enter the encryption key.
3
To switch between input areas, press the <H>
button.
To move the cursor, turn the <5> dial.
In the bottom input area, turn the <5> dial and
press <0> to enter the encryption key.
If you make a mistake, press the <L> button to
erase it.
Press the <7> button to go to the next screen.
To return to the previous screen, press the
<6> button. The entry is erased.
Following the Connection Wizard
1
17