Raid 1 Volume - Asus P8B-C/4L User Manual

5.4.1

RAID 1 volume

The RAID 1 feature supports simultaneous mirrored volumes with two disks.
The RAID 1 feature supports hot swap capability, so when a disk in an RAID
1 volume fails, you can easily restore the volume, and the swapped disk is
automatically re-mirrored.
To create a RAID 1 volume:
1. Turn on the system after installing all SAS hard disk drives.
2. During POST, press <Ctrl+C> to enter the SAS configuration utility.
LSI Corporation MPT SAS2 BIOS
MPT2BIOS-7.05.01.00 (2010.04.30)
Copyright 2000-2010 LSI Corporation.
Press Ctrl-C to start LSI Corp Configuration Utility...
To avoid data loss, do not turn off the system when rebuilding.
3. The following screen appears. Select a channel and press <Enter> to enter
the setup.
LSI Corp Config Utility
Adapter List
Adapter
SAS 2008
Esc = Exit Menu
Alt+N = Global Properties
The numbers of the channel depend on the controller.
5-36
v7.07.00.00 (2010.04.30)
Global Properties
PCI PCI PCI
BUS Dev Fnc
01 00 00
F1/Shift+1 = Help
-/+ = Alter Boot Order
PCI FW Revision
Slot
00 8.00.00.00-IR
Ins/Del = Alter Boot List
Chapter 5: RAID configuration
Status Boot
Order
Enabled 0