Asko T760 Use And Care Manual page 14

REVERSING THE DOOR HINGES REVERSING THE DOOR HINGES
The door hinges on ASKO dryers are reversible. The
dryers are shipped left-hinged. To reverse them, follow
the steps below:
WARNING!
Switch off the main power supply
before you start this procedure.
1. Remove the two 20 torx
screws on the bottom of
the front panel then
grasp the bottom of the
panel and pull it forward
and down.
2. Remove the three
screws holding the
hinge.
3. Supporting the door from the bottom,
pull it out and to the left as you turn
the hinge counter clockwise.
4. Remove the top hinge pin
then turn the hinge
upside down and put the
hinge pin into the top
hole.
5. Repeat steps 1–4 for the bottom hinge.
6. Loosen the two screws on both sides of the door
so you can remove the magnetic door latch and the
cover plate.
7. Remove the door
latch by pushing it up
then lifting it out from
the bottom.
8. Remove the cover
plate by pushing it
down then lifting it out
from the top.
9. Reverse steps 6 and 7 to place the door latch and
cover plate into their new positions.
10. Tighten the screws on the sides of the doors to
hold the latch and cover plate in place.
Page 14
11. Using a flathead screwdriver,
remove the plastic plugs in the
upper and lower edge of the door
and place them in the empty
holes on the opposite side.
12. Remove the screw in the top right
corner of the front panel, as
indicated in the illustration. (If you
have a condenser dryer, you will
need to open the condenser
container door.)
13. Now you are ready to mount the door on the right
side. Holding the door at an angle (as illustrated),
fit the hinge pin into the top hole.
14. Tighten the screws in the order
illustrated at right (a, b, c).
15. Replace the screw you removed
in step 12 (d).
16. Close the condenser container door and replace
the front panel.
17. Turn back on the main power.