Troubleshooting - Dynex DX-DVD2 User Manual

20
• Disc Menu—Lets you set the preferred menu language as the default when
• Default—Resets to all the manufacturer's original settings for this DVD player
4 Press
5 Press SETUP to exit the on-screen menus.

Troubleshooting

Check the following guide for the possible causes and solutions for a problem before
contacting the nearest service center or dealer for repairs.
14
Symptom
No power
No picture
No sound
DVD will not play
The remote control does not
work
Picture is distorted
The control buttons on the
player do not work
playing DVD. (If the DVD supports the language).
Press OK to perform the reset.
(Left) to return to the previous menu.
Solution
Make sure that the DVD player is plugged in and that the AC power connection is
secure.
• Make sure that the connection between the DVD player and the TV is secure.
• Make sure that the TV is in good working condition.
• Make sure that the connection between the player and other devices is secure.
• Make sure that the TV and amplifier are in good working condition and setup
correctly.
• Make sure that the disc is correctly inserted.
• Clean the disc.
• Remove obstacles between the remote control and the player.
• Aim the remote control at the sensor on the front panel of the player.
• Check the battery and replace it if necessary.
• Check the disc for dirt and scratches. Clean or replace the disc.
• Unplug the player, wait ten seconds, then plug it back in and turn it on.
• Power surges or other electrical phenomena may have disabled the buttons.
• Unplug the player, wait ten seconds, then plug it back in and turn it on.
DX-DVD2