Installing Remote Control Batteries - Dynex DX-DVD2 User Manual

10

Installing remote control batteries

To install the remote control battery:
1 Open the battery tray.
2 If this is the first time you will be using the remote control, remove the plastic
insulation sheet that covers the battery.
-OR-
If you are replacing the battery, remove the old battery and insert a new lithium coin
cell battery (CR2025) into the battery tray. Make sure that you match the + symbol on
the battery with the + symbol on the battery tray.
3 Replace the battery tray.
Notes:
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• Battery chemicals can cause a rash. If the batteries leak, clean the battery
compartment with a cloth. If chemicals touch your skin, wash immediately.
• If the remote control is not going to be used for an extended period of time, remove the
batteries.
DX-DVD2