Configuring Network Information; Configuring Network Parameters Tab View - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring Network Information

Verify the type of LAN installation with the customer's network administrator. If
one HP product is installed on a dedicated LAN, network information (IP address,
subnet mask, and gateway address) does not require change.
If multiple HP products are installed or a public LAN segment is used, network
information must be changed to conform to the customer's LAN addressing
scheme.
Perform the following steps to change a product's IP address, subnet mask, or
gateway address.
1. Choose Configure from the navigation panel.
2. Click the Switch or Director tab, then click the Network tab to display the
Figure 9: Configuring network parameters tab view
3. Click Activate to save and activate the changes. The following message box
Embedded Web Server User Guide
Network tab view (Figure
a. At the IP Address field, type the new value specified by the customer's
network administrator (default is 10.1.1.10).
b. At the Subnet Mask field, type the new value specified by the customer's
network administrator (default is 255.0.0.0).
c. At the Gateway Address field, type the new value specified by the
customer's network administrator (default is 0.0.0.0).
displays (Figure 10).
9).
Configuring the Product
45