Table of Contents
Advertisement
The Dell PowerConnect W-6000 controller Power Supply adapts electrical power for use with the W-6000
controller. The W-6000 chassis has three slots that can hold individual power supplies to support load sharing and
fault tolerance.
This chapter describes the general features and physical characteristics of the power supply and important power
consumption management information. The final sections of the chapter cover the steps required to insert and
remove power supplies.
Features
Rating
The Dell W-6000 Power Supply (HW-PSU-400) is rated at 400 W total output and is auto-ranging to accept 85
to 264 VAC, at 50 to 60 Hz. Up to three 400 W power supplies can be installed in the W-6000 controller.
Load Sharing
Load sharing occurs when more than one power supply of the same rating are installed in the W-6000 controller
and turned on. Load sharing divides the total power load of the W-6000 among all plugged in power supply
modules. Since the power supplies work together, the effective power capacity of the chassis is increased by with
each additional power supply.
Redundancy
When multiple power supplies are installed, if one becomes unavailable (fails, or is turned off or removed) the
remaining power supplies will attempt to provide full power for the W-6000 controller. If the total power load
does not exceed the combined rated output of the remaining, operational power supplies, the W-6000 will
continue to operate. For more information on power supply configurations,
Hot Swap
Hot swapping should be performed by a trained technician. Hot swapping allows you to replace one failed power
supply while the others provide full power. This makes it unnecessary to shut down the W-6000 controller during
the replacement procedure.
Hot swapping requires that after the target power supply is removed, the chassis's total power load does not
exceed the combined rated output of the remaining power supplies.
Dell PowerConnect W-6000 Controller | Installation Guide
Chapter 6
The W-6000 Power Supply Module
"Power Management" on
The W-6000 Power Supply Module | 23
page 25.
Advertisement
Table of Contents
