Setting Terminal: Cn2 - Fujitsu MAF3364LC - Enterprise 36.4 GB Hard Drive Product Manual

B.1 Setting Terminals
Setting item Pins
9 - 10 7 - 8
SCSI ID (Open) Open
(Open) Open
(Open) Open
(Open) Open
(Open) Short
(Open) Short
(Open) Short
(Open) Short
Short
Short
Short
Short
Short
Short
Short
Short
Write protect Open
Short
* Setting at factory shipment (*1: LC/MC, *2: LP/MP)
For LP/MP models
Setting item
11 - 12
Motor start mode Open
Short
Force Narrow
Force Single Ended
Terminating power
supply
* Setting at factory shipment
B - 2
Table B.1

Setting terminal: CN2

5 - 6 3 - 4 1 - 2
Open Open SCSI ID #0
Open Short SCSI ID #1
Short Open SCSI ID #2
Short Short SCSI ID #3
Open Open SCSI ID #4
Open Short SCSI ID #5
Short Open SCSI ID #6
Short Short SCSI ID #7
Open Open Open SCSI ID #8
Open Open Short SCSI ID #9
Open Short Open SCSI ID #10
Open Short Short SCSI ID #11
Short Open Open SCSI ID #12
Short Open Short SCSI ID #13
Short Short Open SCSI ID #14
Short Short Short SCSI ID #15
Write operation is enabled.
Write operation is disabled.
Pins
13 - 14 15 - 16 23 - 24
Open
Short
Open
Short
Open
Short
C141-E064-03EN
Setting contents
(Common to 8-bit and 16-bit SCSI) (*1)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
(16-bit SCSI only)
Setting contents
Started by the START/STOP command
Started by turning the power supply on (*)
Width of 16 bit bus (*)
Width of 8 bit bus
Follows DIFFSNS signal level on SCSI bus (*)
Single-Ended mode
Does not supply terminating resistor power to SCSI
BUS
Supply terminating resistor power to SCSI BUS (*)
(*2)