Dismounting Drives - Fujitsu MAF3364LC - Enterprise 36.4 GB Hard Drive Product Manual

a. Control mode parameters
• Queue algorithm modifier
• QErr:
• DQue:
5.7

Dismounting Drives

Since dismounting the drive to check the setting terminals, change the setting, or change the
drive depends on the structure of the system cabinet, the work procedures must be determined
in consideration of the requirements specific to the system. This section describes the general
procedures and notes on dismounting the drive.
It is recommended before dismounting the drive to make sure the spindle motor completely
stops after power was turned off.
a) Remove the power cable.
b) Remove the SCSI cable.
c) When the external operator panel is mounted, remove the cable. If it is difficult to access
the connector position, the cable may be removed after step e).
d) Remove the DC ground cable.
e) Remove the four mounting screws securing the drive, then remove the drive from the
system cabinet.
f) To store or transport the drive, keep it in an antistatic bag and provide packing (see Section
5.1).
5 - 22
Parameter
Resume or abort remaining suspended
commands after sense pending state
Disabling tagged command queuing
C141-E064-03EN
Default value
0 (Ordering is
executed by read
command only.)
0 (command is
resumed)
0 (enabled)