Table of Contents
Advertisement
2
OPERATION
2.1 Cabinet Operation
If the cooler has been disconnected from the power supply for any
reason, allow about 10 minutes before switching it back on. This
allows the refrigeration system pressure to equalise before the
system is restarted.
Before operating the cooler, ensure:
• the cooler is positioned on a level surface.
• the maximum operating conditions are 40°C at 75% RH.
• there is adequate ventilation around the refrigeration unit.
• there is a gap of at least 35mm behind the cabinet.
• the plastic drain pin (included in the bag with the operating
instructions) is placed into the drain hole in the cabinet liner
bottom (see Figure 2 below). This prevents objects from
covering the drain hole.
• the cabinet stabiliser foot is screwed firmly down to floor level
(see Figure 3 below).
• the cooler is allowed to stand for at least 30 minutes before
connecting to the power supply.
Figure 2: Drain Hole Pin
HB80/110 Serene Glass Door Cooler
User Manual
Stabiliser Foot
Figure 3: Cabinet Stabiliser Foot
7
Advertisement
Table of Contents
