Bosch SGV45E03UC Use & Care Manual page 14

Figure 21
A
B
Figure 22
Figure 23
Figure 24
To open - turn counterclockwise.
14
To remove the top spray arm:
1. Remove the empty top rack from the dishwasher.
2. Turn the rack upside-down. The top spray arm is held in position by a locking nut as
shown in Figure 21A. Turn the locking nut counter-clockwise 1/8 turn and remove it,
as shown in Figure 21B to release the spray arm.
3. Remove the spray arm as shown in Figure 22.
4. Look for obstruction in the spray nozzles.
To reinstall the top spray arm:
1. Return the top spray arm to its installed position.
2. Return the locking nut to its installed position and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in Figure 23.
3. Look for obstruction in the spray nozzles.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed position and press it so that it snaps into
place.
2. Return the bottom rack to its installed position.
Check/Clean the Filter System
located on the inside of your dishwasher under the lower rack and is easily accessible.
foreign objects and clean it when necessary.
CAUTION
object trap could contain sharp objects.
under the lower rack and is easily accessible.
foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 24 and turn it counter-
clockwise 1/4 turn.
3. Lift out the assembly as shown in Figure 25.
upside-down and gently tap it on a surface such as a countertop to dislodge and
remove the debris. Flush the Cylinder Filter clean by holding it under running water.
To Remove the Fine Filter: