Completing The Installation; Closing The Blade Server Cover - IBM JS21 - BladeCenter - 8844 Installation And User Manual

Completing the installation

To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Close the blade server cover (see "Closing the blade server cover").
2. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
3. Turn on the blade server (see "Turning on the blade server" on page 11).
4. For certain optional devices, run the blade server SMS Utility program.

Closing the blade server cover

Attention:
cover is installed and closed. Do not attempt to override this protection.
The following illustration shows how to close the blade server cover.
Cover
pins
To close the blade server cover, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear
24
BladeCenter JS21 Type 8844: Installation and User's Guide
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
server in a BladeCenter unit" on page 25).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade
server flashes slowly before you press the power-control button.
You cannot insert the blade server into the BladeCenter unit until the
on page 15.
of the blade server, as shown in the illustration. Before you close the cover,