IBM JS20 - BladeCenter - 8842 Installation And User Manual page 72

Checkpoint code Description
E203 Disable the TimeBase (TB) function.
E204 CRC check of the image in RAM.
E206 Reenable the TimeBase (TB)
function.
E209 Serial input/output (SIO),
communication line 1 (COM1), and
general purpose input/output (GPIO)
initialization.
E20A Load 256 K flash code into Level 2
(L2) cache.
E20B Read startup mode.
E20C Control of the master processor has
been transferred to the Partition
FirmWare (PFW).
E20D Startup mode has been obtained.
E20F Run from Level 2 (L2) cache.
60
BladeCenter JS20 Type 8842: Installation and User's Guide
Suggested action
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.