Communicating Directly With A Blade Server - IBM JS20 - BladeCenter - 8842 Installation And User Manual

Notes:
1. Some options have device drivers that you must install. See the documentation
2. The IBM Remote Deployment Manager (RDM) program does not support the

Communicating directly with a blade server

After you have completely installed and configured the operating system, you can
use a Telnet or SSH session to communicate directly with the JS20 Type 8842
blade server operating system. See the documentation for your operating system
for information about using its command-line interface.
46
BladeCenter JS20 Type 8842: Installation and User's Guide
that comes with the options for information about installing any required device
drivers.
If your operating system does not have the required device drivers, contact your
IBM marketing representative or authorized reseller, or see your
operating-system documentation for additional information.
BladeCenter JS20 Type 8842. However, you can use the following programs for
remote deployment:
v For AIX, Red Hat Linux, or SUSE LINUX operating-system deployments, you
can use Cluster Systems Management (CSM) from IBM. Go to
http://www.ibm.com/servers/eserver/clusters/software/.
v For AIX operating-system deployments, you can use Network Installation
Manager (NIM) from IBM. See your AIX operating-system documentation for
additional information.
v For SUSE LINUX operating-system deployments, you can use the AutoYast
utility program from SUSE LINUX. Go to http://www.suse.de/~nashif/
autoinstall/.