Closing The Blade Server Cover - IBM HS40 - BladeCenter - 8839 Installation And User Manual

3. Insert the tabs on the bottom of the bezel up into the matching holes on the

Closing the blade server cover

Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustration shows how to close the blade server cover.
Cover
pins
Air baffle
Complete the following steps to close the blade server cover:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If you removed the blade bezel assembly, replace it now. See "Installing the
3. Before closing the cover, check that all components are installed and seated
46
BladeCenter HS40 Type 8839: Installation and User's Guide
server chassis; then, rotate the top of the bezel toward the server until the tabs
at the top of the bezel snap into place.
on page 21.
blade server bezel assembly" on page 45 for instructions.
correctly and that you have not left loose tools or parts inside the blade server.
Blade cover