Panasonic BT-LH1710 - Professional - LCD Production Monitor Operating Instructions Manual page 26

Main Menu
(continued)
• PART
Resizes the main window to show only its center to also display a second image (two sub-windows).
Press the FUNCTION button to which the SUB WINDOW function has been assigned.
Normal window
(main window)
Video
Crops the image to show its
center part
Note on FULL/PART selection
This function is designed to enable comparison of identical formats input to the same input terminal. Input of
different formats via different input channels may distort the sub-window (left side, still image) or blanking could
occur. However, input of an identical format signal to the input terminal during still image acquisition will display
correctly.
■ "WFM/VECTOR"
The "WFM/VECTOR" function enables display of the waveform and vector display. Use "DISPLAY SETUP" in the
main menu to select "WFM" and "VECTOR" display. (
Press the button ([FUNCTION1] to [FUNCTION5] (
assigned to turn the function on and off. (This assumes that the "WFM/VECTOR" function has been assigned to
any of the [FUNCTION1] to [FUNCTION5] buttons.)
Press the FUNCTION button to which the WFM/VECTOR function has been assigned.
Normal screen
*1 Displayed only for SDI signal input.
26
Before image input
(two sub-windows)
Press the
button again
Video
The cropped main window image
is placed side by side with a
second image
WFM display
Press the
button again
WFM (waveform display)
Press the
button again
Video
These examples show 16:9 aspect ratio images.
page 33)
page 23)) to which the "WFM/VECTOR" function has been
Press the
button again
These examples show 16:9 aspect ratio images.
After image input
(two sub-windows)
Still image Video
*1
VECTOR display
VECTOR
(vector display)