Advertisement
[LED All Lit, Key Check Mode]
Procedure:
1. Press the
?/1
button to turn the power ON.
2. Press three buttons of
[DISC 5]
simultaneously.
3. LEDs are all turned on.
Press the
G
(CD) button, and the key check mode is activated.
LEDs are all OFF.
4. When a button is pressed, the LED near the pressed button
blinks or lights up.
Also, if all buttons are pressed, all LEDs light up (not blink).
5. To release from this mode, press three buttons in the same
manner as step 2, or remove the power cord.
[CD Delivery Mode]
• This mode moves the optical pick-up to the position durable to
vibration. Use this mode when returning the set to the customer
after repair.
Procedure:
1. Press the
button to turn the power ON.
?/1
2. Press the
s
(DECK B) and
3. A message "LOCK" is displayed on the liquid crystal display
of the STR-NX1/NX3, and the CD delivery mode is set.
[Tape Deck Test Mode]
(In case of connected to the STR-NX1/NX3)
• If connected to the STR-NX1/NX3, the mode also acts as the
STR-NX1/NX3 amplifer test mode.
Procedure:
1. Press the
?/1
button to turn the power ON.
2. Press three buttons of
(DECK B),
s
simultaneously.
3. On liquid crystal display of the STR-NX1/NX3, the disc cal-
endar blinks, and "ALC OFF" is displayed, then the function
which was set before the test mode became active is displayed.
4. The automatic level control of the tape deck is in OFF status,
but while the
(CD) and
s
pressed during recording, automatic level control goes in ON
status.
[Tape Deck Test Mode]
(In case of connected to the power feed jig)
Procedure:
1. Turn on the Power switch on the power feed jig.
2. Press three buttons of s (DECK B), A (DISC 1),
and s (CD) simultaneously.
3. The G (CD) and S (CD) LEDs blink, and then pressing G
(CD), G / g (DECK A), or G / g (DECK B) button can
make each play possible.
4. Also, the other functions are enabled by pressing two buttons
simultaneously.
A combination of respective functions and buttons is as fol-
lows.
function
CD AMS –
AMS +
FR
FF
Deck-A REW/AMS –
FF/AMS +
Deck-B REW/AMS –
FF/AMS +
Note: Check that CD/TC signal change switch of relay connector jig is
set to the TC position.
TEST MODE
s
(DECK B),
A
(DISC 1), and
[DISC 1]
buttons simultaneously.
(DISC 1), and
A
S
[REC PAUSE/START]
buttons are
button
s (DECK A), S (CD)
s (DECK A), s (CD)
s (DECK B), S (CD)
s (DECK B), s (CD)
s (CD), g (DECK A)
s (CD), G (DECK A)
s (CD), g (DECK B)
s (CD), G (DECK B)
SECTION 4
(CD)
13
Hide quick links:
Advertisement
Chapters
