How To Configure Multi-Point Wireless Bridging - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual
Prosafe 802.11g wireless access point
Hide thumbs
Also See for WG102 - ProSafe Wireless Access Point:
- Reference manual (118 pages) ,
- User manual (23 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
How to Configure Multi-Point Wireless Bridging
Figure 5-7: Multi-Point bridging
Configure the Operating Mode of the WG102 Access Points.
1.
•
Because it is in the central location, configure WG102 (AP1) on LAN Segment 1 in
Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in
AP1.
•
Configure WG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode with the
Remote MAC Address of AP1.
•
Configure the WG102 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote
MAC Address of AP1.
Verify the following parameters for all access points:
2.
•
Verify that the LAN network configuration of the WG102 Access Points are configured to
operate in the same LAN network address range as the LAN devices
•
Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in
Point-to-Point Bridge mode.
•
All APs must be on the same LAN. That is, all the APs LAN IP address must be in the
same network.
Advanced Configuration
November 2005
5-11
Advertisement
Table of Contents
