Loading Nails - Hitachi NT65GA - 2-1/2" Gas Powered 34 Angled Finish Nailer Instruction And Safety Manual

English
4 Close the actuator.
(4) Remove the finger from the trigger and
press the push lever against the
workpiece with pulling back the nail
feeder (B). (NT50GS: Unnecessary to
pulling back nail feeder)
THE NAILER MUST NOT OPERATE.
Do not pull trigger
Depress push lever
(5) Separate the push lever from the
workpiece.
Next, point the nailer downward, pull the
trigger and then wait in that position for
5 seconds or longer.
THE NAILER MUST NOT OPERATE.
Pull trigger
(6) Without touching the trigger, depress the
push lever against the workpiece.
Pull the trigger.
THE NAILER MUST OPERATE.
24
2. Push down
1. Swing back
Nail feeder (B)
(7) If no abnormal operation is observed, you
may load nails in the Nailer.
Drive nails into the workpiece that is the
same type to be used in the actual
application.
THE NAILER MUST OPERATE
PROPERLY.

LOADING NAILS

WARNING
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
<NT65GS, NT65GA, NT65GB>
2–Action Nail Feeding!
(1) Insert nail strip into the back of the
magazine.
(2) Slide the nail strip forward in the
magazine.
Magazine