Table of Contents
Advertisement
Available languages
Available languages
BM 1619929800 12-07
BATTERY CHARGED CONDITION
INDICATOR
The battery is equipped with a charged
condition indicator (Fig. 10).
GREEN
INDICATOR LIGHTS
BUTTON
By pressing the button ON, the charged
condition can be checked when the battery is
removed or when the machine is not in use.
After approx. 5 seconds, the charged indicator
switches off automatically.
• • • When all three lights are illuminated, this
indicates the battery pack is between 67% and
100% charged.
• •
When only two lights illuminate, this
indicates the battery pack is between 33% and
66% charged.
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position and the red warning label is no longer
visible (Fig. 1).
Your battery pack is equipped with a
secondary locking latch to prevent the battery
pack from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward. The red warning label will become
If the indicator lights are "OFF", the charger is
not receiving power from power supply outlet.
If the green indicator light is
"ON", the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged.
12/4/07
8:32 AM
FIG. 10
RED
INDICATOR LIGHT
INSERTING AND RELEASING BATTERY PACK
CHARGER INDICATORS, SYMBOLS AND MEANING
Page 12
•
When only one light illuminates, this
indicates the battery pack is less than 33%
charged.
When one light blinks the battery pack is
almost fully discharged.
TEMPERATURE INDICATOR LIGHT
The red indicator light signals whether the
battery or tool (with battery inserted) is in the
optimum temperature range. When the
temperature is too high, the tool will not operate
at full capacity.
If the red indicator light illuminates continuously
when the battery is inserted into the charger.
The battery is outside the charging temperature
range and cannot be charged.
If the red indicator light blinks when the button
or on/off switch (with battery inserted) is
pressed, the battery is outside the operating
range of -10 ˚C to +60 ˚C.
When the temperature is above 70 ˚C the
battery turns off until it's in the optimum
temperature range.
partially visible. Press the battery pack release
button again and slide the battery pack
completely out of tool housing (Fig. 11).
If the green indicator light is
"BLINKING", the battery pack is
being
charging will automatically stop when the
battery pack is fully charged.
-12-
FIG. 11
fast-charged.
Fast-
Advertisement
Table of Contents
