Toshiba M200 - Portege - Pentium M 1.5 GHz User Manual page 190

190
If Something Goes Wrong
Resolving a hardware conflict
Connect your computer directly to your router or broadband
modem, by plugging a standard CAT5 Ethernet patch cable
(sold separately) into your computer's RJ45 Ethernet port. If
your connection problem disappears, the problem lies in the
Wi-Fi
Use the PING command to verify a connection to the gateway
at 192.168.1.1 (a default gateway for most wireless routers).
If you have enabled any security provisions (closed system,
MAC address filtering, Wired Equivalent Privacy [WEP], etc.),
check the access point vendor's Web site for recent firmware
upgrades. Problems with WEP keys, in particular, are
frequently addressed in new firmware releases.
Special considerations for the Windows
Wired Equivalent Privacy (WEP) encryption is not enabled
on the wireless access point.
When you install a wireless access point device, the Windows
operating system checks whether WEP encryption is enabled on the
device. If it is not enabled, the Windows
device to its list of available wireless networks, but does not create a
wireless connection using the device, since the connection would
not be secure. You can still, however, use the access point. To use an
access point without WEP encryption, follow these steps:
1 Right-click the Wireless Network icon in the System Tray
(far-right portion of the Windows
2 Click View Available Wireless Networks.
3 Select Allow me to connect to the selected wireless network,
even though it is not secure.
4 The Windows
wireless connection.
®
part of your network.
Click Start, then click Run...
Enter and press
Cmd
Enter PING 192.168.1.1
.
Enter
If "Request Timed Out" or another error message appears
in response, then the problem is probably Wi-Fi
®
operating system will now try to establish a
.
Enter
at the command prompt, and press
®
operating system
®
operating system adds the
®
Taskbar).
®
-related.
®