Switching Off The Projector - Panasonic PT-LB90NTEA Operating Instructions Manual

Switching the projector on/off

Switching off the projector

When operating the projector, check the status of the POWER indicator. (
POWER indicator
POWER LOCK indicator
1 ) Press the POWER button.
The confirmation screen will be displayed.
Without any operation for 10 seconds or press any button other than the
z
screen will go off and return to the projection.
2 ) Press the POWER button again.
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
z
indicator and POWER indicator turn into red.
If STANDBY MODE is set to NORMAL, the POWER indicator flashes in red. (
z
You can set to
z
AUDIO SETTING.
( page 43)
Æ
3 ) After the POWER LOCK indicator and POWER indicator light in red, disconnect the
mains plug from the mains socket. (
For urgency, you may disconnect the mains plug immediately since the
z
installed.
Remarks
Confirm that CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when
z
operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE.
( page 46)
Æ
You can switch off the power by pressing the
z
E
24 - NGLISH
ON or OFF the beeping sound that occurs when the POWER button is in operation in
Æ
INPUT SELECT
RELEASE
POWER indicator lights in orange. Wait until the POWER LOCK
page 21)
Æ
POWER button for 0.5 seconds or more.
page 22)
(1), (2)
POWER button, the confirmation
page 42)
Æ
DIRECT POWER OFF function is