10.0-10.2 Feature Enhancements; Turbo Iii Speeds Supported For Scan-To-Net; Check Plot Checkbox; Copier Margin Range Increased To +/- 8 Inches - Xerox 850DP - Phaser Color Solid Ink Printer Release Note

7 10.0-10.2 Feature Enhancements

The following features were added in releases between 10.0 and 10.2 and are listed here as a
convenience for users.

7.1 Turbo III speeds supported for Scan-To-Net

The 7.33 ips scanning mode which is enabled by turbo III feature key is now supported for scan
to net scans in normal mode.

7.2 Check Plot checkbox

A new checkbox is now available to specify if check-plots should be printed during the scanning
of a copy set or not. The checkbox is on the "Sets Build" screen.
When scanning in a copy set, the system would often print each page as it was scanned in to
show the copy quality of the page. There was a complex algorithm that decided if a check-plot
should be printed based on the collation order and the stacking order of the tray or folder.
Version 10.2 replaces the algorithm with a checkbox on the set build screen to allow the user to
specify if a check-plot should be printed or not regardless of collation.

7.3 Copier Margin range increased to +/- 8 inches

The margin settings for copies can now be specified up to +/- 8 inches. This menu can be
reached by selecting the "Transform" key on the scanner UI and selecting "Margins"

7.4 Disk Logging setting added to WebPMT

On the "Printer Setup" page there is a new checkbox for "Disk Logging" which is used for
enabling and disabling the log of system messages to the hard drive. These messages are
especially useful to trained Xerox personnel when diagnosing problems. Turning disk logging off
does not erase the log file, it simply closes it and does not write any more records to it. Turning
disk logging on begins to append new information to the bottom of the log file.
The default setting is "ON"
7.5 Added support for 440, 620 and 880mm rolls
for 6030/6050 printers
Support for these special ISO sizes has been added for the 6030/6050 printers.
To use these sizes, the roll must be configured for the "Spa2" series.
There is a known issue with using 880mm media causing YKE systems to lock-up.
Page 12