Configuring Hp-Ux V8.07 For Printing With The Okilan 6020E - Oki B4200 User Manual

Section 4 - Appendix B - Application Considerations
Configuring HP-UX v8.07 for Printing
with the OkiLAN 6020e
This application note describes the configuration of the
printing system on the HP-UX ver. 8.07 of the UNIX
operating system. For clarity and brevity, the following
specific names will be used to represent general
devices or concepts.
• lj4 - The local queue name on the HP-UX system
to which print jobs that are destined for a printer
attached to the OkiLAN 6020e will be directed.
• OKIPRINTER - The host name of the remote
system which is the OkiLAN 6020e. For example,
to telnet to the OkiLAN 6020e and invoke the
OkiLAN 6020e Configuration utility, you would
type telnet OKIPRINTER. A host name is not
required for the OkiLAN 6020e, the IP Address
may be used.
• yourqueuename - This is the name of the queue
on the OkiLAN 6020e and must end with 1, 2, 3
or 4, depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See pages IV-15 and IV-16 for more
information on remote queue names.
Prerequisites
Before you proceed, the following prerequisites must
be met. Most of the time, steps 2 through 5 are already
configured since the HP-UX system is on a TCP/IP
network. Do not perform steps 2 through 5 unless the
installation procedure fails!
1. The name OKIPRINTER and the IP address
assigned to the OkiLAN 6020e are in the
"/etc/hosts" file on the HP-UX system.
OKI OkiLAN 6020e User's Guide IV - 63