Installation And Manual Setup Via The Web Setup Interface; Accessing The Web Setup Interface - Sagem 3100MFPX - Phaser B/W Laser User Manual

Sagem_Fax_ATA101S.book Page 3 Jeudi, 21. février 2008 5:09 17
I
NSTALLATION AND MANUAL SETUP
)
INTERFACE
When you do not have many units to set up, it is recommended to set
up the ATA through the Web interface. This setup mode allows you to
set up your Sagem Fax ATA 101S simply and quickly.
This method is recommended when installing and
setting up 1 to 10 units.

Accessing the Web setup interface

1. Connect the LAN RJ45 connector located at the rear of the unit
directly to your computer via a crossed cable, or to a Hub/Switch
via a straight cable.
Make sure to use a Hub/Switch that is not
connected to your computer network. This will
avoid any IP address conflicts.
2. Set up your network card so that it is located in the same IP
network as the LAN connection socket of your Sagem Fax ATA
101S.
You can use the following default IP settings:
• IP address:
• Sub-network mask: 255.255.255.0
• Default gateway:
User guide
( W
VIA THE EB SETUP
Note
Important
192.168.134.10
blank
3