Lexmark 734de - X Color Laser User Manual page 184

Menu item
Location
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Standby Mode
Disabled
2–240
Timeouts
Power Saver
1–240
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Description
Specifies the location of the printer
Note: The location will be stored on the Embedded Web Server.
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
•
Off is the factory default setting for Cartridge Alarm. Off
means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Sets the amount of time the printer waits after a job is printed
before it goes into a reduced power state
Notes:
•
30 minutes is the factory default setting.
•
Lower settings conserve more energy, but may require longer
warm-up times.
•
Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print with
minimum warm-up time.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive an
end-of-job message before canceling the remainder of the print
job
Notes:
•
90 seconds is the factory default setting.
•
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Understanding printer menus
184