Table of Contents
Advertisement
5.2
NVIDIA
The motherboard includes a high performance SATA RAID controller
integrated in the NVIDIA
controller supports RAID 0, RAID 1, RAID 1+0, and JBOD using the four
independent Serial ATA channels or two IDE connectors, or both.
5.2.1
5.2.1
5.2.1
5.2.1
5.2.1
Setting the BIOS RAID items
Setting the BIOS RAID items
Setting the BIOS RAID items
Setting the BIOS RAID items
Setting the BIOS RAID items
After installing the hard disk drives, make sure to set the necessary RAID
items in the BIOS before setting your RAID configuration.
To set the BIOS RAID items:
1.
Enter the BIOS Setup during POST.
M a i n M e n u
M a i n M e n u
2.
Go to the M a i n M e n u
M a i n M e n u
M a i n M e n u, select I D E C o n f i g u r a t i o n
<Enter>.
3.
Set the R A I D O p t i o n R O M
R A I D O p t i o n R O M
R A I D O p t i o n R O M
R A I D O p t i o n R O M item to [Enabled], then press <Enter>.
R A I D O p t i o n R O M
The master and slave drive list appears.
4.
Enable the drives you want to set as RAID.
5.
Save your changes, then exit the BIOS Setup.
•
Refer to Chapter 4 for details on entering and navigating through
the BIOS Setup.
•
The RAID BIOS setup screens shown in this section are for reference
only, and may not exactly match the items on your screen.
A S U S K 8 N - D R E
A S U S K 8 N - D R E
A S U S K 8 N - D R E
A S U S K 8 N - D R E
A S U S K 8 N - D R E
®
RAID configurations
®
nForce Professional 2200 chip. The RAID
I D E C o n f i g u r a t i o n
I D E C o n f i g u r a t i o n
I D E C o n f i g u r a t i o n, then press
I D E C o n f i g u r a t i o n
5 - 3
5 - 3
5 - 3
5 - 3
5 - 3
Advertisement
Table of Contents
