Asus F1A55-M LX Series User Manual page 35

4. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you
can create a RAID 0, RAID 1, RAID 10, or JBOD configuration through the onboard
controller.
F1A55-M LX PLUS
F1A55-M LX PLUS SATA 3.0Gb/s connectors
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
ASUS F1A55-M LX Series
SATA3G_4
RSATA_TXP6
RSATA_TXN6
RSATA_RXN6
RSATA_RXP6
SATA3G_3
RSATA_TXP5
RSATA_TXN5
RSATA_RXN5
RSATA_RXP5
SATA3G_2
SATA3G_1
XP Service Pack 3 or later version before using Serial
®
XP SP3 or later version.
®
SATA3G_6
GND
GND
GND
SATA3G_5
GND
GND
GND
1-23