General Error Function; Alignment And Adjustments - Samsung WF350ANP/XAA Technical Information

ALIGNMENT AND ADJUSTMENTS

To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.

GENERAL ERROR FUNCTION

Error Diagnostic Code
NO
Code Error Image
1 nd
2 LO
3 nF
4 FL
5 LE
6 LE
7 OE
8 dc
9 E2
10 dL
The water level fails to drop below
1
the Reset Water Level within 15
minutes.
Door fails to Unlock After 7
2
attempts.
When the filling Continues for
3
more than 40 minutes or there is no
change of water level for 6 minutes.
4
Door fails to lock after 7 attempts.
A water level lower than the Reset
water level (25.6Khz) is detected for
8
5 seconds during the Wash/Rinse
cycle.
Water Level Sensor Trouble. (When
the input signal from the water level
8
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
A fault is detected in the water level
sensor. Data (frequency) shows
the water level is at or above the
overflow water level. (When this
E
condition is detected, the machine
will automatically starts draining
water until the water level falls
below the overflow water level)
Unbalance or cabinet bump is
detected during final spin, which
10
prevents the drum from spinning
over 150 rpm. (Never exceeds 150
RPM due to unbalanced load)
Jammed Key.(When key input
signals are coming out for more
15
than 30 seconds, it is regarded as
a jam.)
Door is detected as open when the
18
motor is operating.
WARNING
Description

Corrective Action
Go to " Will Not Drain"
Troubleshooting Section.
Go to " Will Not Unlock"
Troubleshooting Section.
Go to " No Water Fill"
Troubleshooting Section.
Go to " Will Not Lock"
Troubleshooting Section.
Go to "No Water Fill"
Troubleshooting Section.
Go to "No Water Fill"
Troubleshooting Section
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level sensor.
Go to "Wet Clothes" Troubleshooting
Section.
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
Check for loose wire connections. Go
to "Quick Test Mode" and then do Door
lock/Unlock Test and Motor Test.