Table of Contents
Advertisement
Follow these steps to m o d e each of the Preset Equalization buttons.
_.
First, select one of the Preset Equalization buttons.
I
SEEK
I
1.
Settings Either
F
(Factory),
U
(User) or P
(Program)
2. Equalization Bands
(1
thru 5}
3.
Equalization Gain
(1 thru 15)
2. Press the SET button, and then press and hold the Preset Equalization
button you have selected, until either an F or U is displayed (about
10 seconds).
The display will show either 3 or 4 digits and the preset button LED
will flash. In the farthest right position of the display will be an F (for
factory setting), or if the equalization has been modified, a U (for user
setting).
3. Press the SCAN switch up or down to select the band you prefer.
The middle digit indicates the equalization band. There are five bands:
60Hz, 250Hz, lkHz, 3.5Hz and lOkHz, numbered 1 through 5
respectively. The band will display band 1 when the mode is first entered.
Press the SEEK switch up or down to select the gain setting you wanr.
The left digit, or two digits are the equalization gain settings (0-15) for
each band. The display will indicate the active setting (F or U) when
the mode is first entered. A typical setting for a flat response is
7.
I
3- 10
Advertisement
Table of Contents
