Table of Contents
Advertisement
Then, without shutting off the engine, follow these
stem:
1. Pull out the dipstick and
wipe it with a clean rag
or paper towel.
2.
Push it 'back in
aa
the way, wait three seconds and
I
:then pull it back out again.
3.
Check both sides
ofthe
dipstick, and read the
lower level. The fluid
level must be
. i n
the
cross-hatched mea.
P
4. If the fluid level is where
it
should be, push the
How to Add Fluid:
dipstick back in all the way.
Refer to the Maintenance Schedule to determine what
kind of transaxle fluid to use. See "Recommended
Fluids and Lubricants" in the Index.
If the- fluid level is low, add only enough
of the proper
fluid to bring the level into the cross-hatched area on the
dipstick. It doesn't take much fluid, generally less than a
pint. D,on't overfill. We recommend you use only fluid
labeled DEXRONB-IIE, because fluids with that label
230
Advertisement
Chapters
Table of Contents
