VMware VCENTER CONFIGURATION MANAGER 5.3 Getting Started Manual page 214

vCenter Configuration Manager Installation and Getting Started Guide
9. Verify the method used for communication. The default communication method is DCOM. For most
VCM for Active Directory configurations, the default values in this screen should be used.
Click Next. The Schedule page appears.
10. Select Run Action now, and then click Next.
11. Click Finish. The Selected Domain Controllers are moved from the Available Machines list to the
Licensed Machines list, and an Install job is submitted to initiate the Agent installation on each Domain
Controller.
Disabling UAC for Agent Installation
The following steps are required only if you are installing the Agent on a Windows 2008 or Vista machine.
When installing the Agent on Windows 2008 or Vista, you must disable the User Account Control (UAC),
install the Agent, and then re-enable the UAC.
Disabling UAC on One Machine
1. On the target Windows 2008 machine, click Start | Run. The Run dialog box appears.
2. Type msconfig in the Open text box.
3. Click OK. The System Configuration dialog box appears. (This dialog box differs for Windows 2008
R2 machines.)
214 VMware, Inc.