3) Remove the Pressure roller spring and Pressure roller bearing on both sides, and
the Pressure roller.
Note:
Do not use the electric driver to loosen/secure the screw as the plastic bush is
easy to break.
Pressure roller spring
< Reassembly >
Using the Release spacer L & R may help to assemble springs.
1.29
Transfer Unit
(1)
Loosen a screw.
(2)
Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit ( A ) and
slide it to the right ( B ) (See Figure 4.56)to take off the left part from the main
chassis L. Remove the transfer unit from the body by lifting the former.
Main chassis L
Pressure roller bearing
Fixing unit chassis
Figure 4.56
Screw
Figure 4.57
B
A
IV-27
Pressure roller
Transfer unit
<Right>