Brother HL 1270N - B/W Laser Printer Network User's Manual page 104

BRCONFIG
In some cases you may see a message like Console Connected or Remote Console
Reserved when you connect to the print server. If this happens, press RETURN or ENTER
to get the "#" prompt, enter the password "access" (the password will not appear on the
screen), and type anything in response to the Enter Username> prompt. When you get the
Local> prompt, you are ready to enter commands.
General Server Commands
CLear FATal
Deletes the fatal error log
CLear POrt portname JOB
Clears current entry in the print server's internal queue for the specified portname (P1 for the
printer.)
EXIT/^D
Exits print server console
HElP
Provides information on available commands
INitialize
Resets print server
SET DEFAULT
Sets print server parameters to factory defaults
SET LOAD DIsable
Disables firmware reload after exit
SET LOAD ENable
Enables firmware reload after exit
Brother BRCONFIG utility runs on the DOS system prompt and is installed
with BRAdmin32. To connect the print server using the Brother BRCONFIG
NetWare utility, Choose the BRCONFIG utility from the Brother
BRAdmin32 utilities menu or insert the Brother BRAdmin32 utility diskette
into Drive A and type: A:BRCONFIG at the DOS system prompt. If you
have only one print server, you will be immediately connected to that server.
If you have more than one print server, you will be given a list of available
print servers. Type the number of the print server to which you wish to
connect. When you are connected, enter the password "access" (the password
will not appear on the screen) at the "#" prompt, and type anything in
response to the Enter Username> prompt. When you get the Local>
prompt, you are ready to enter commands. To use BRCONFIG, a Novell
Server (running the IPX protocol) is necessary and an active connection must
be made to the server..
A-2