Table of Contents
Advertisement
NAVIGATION
(including any tolerance you have set) for the road you are on the speed limit icon will flash
and the unit will beep.
When the option is shown with an orange indicator it is activated.
When active you can then change the speeding tolerance using the
and
keys to
select the tolerance you would like from 0%, 5%, 10%, 15% and 20%. The unit will then
only warn you when you exceed the speed limit by more than this percentage.
Set the required options and tap
to confirm the unit will then return to the settings
screen.
8.3 Trace Record
The unit is capable of logging all positioning
information received from the GPS satellites
during navigation. It then uses this information
to draw a track of the route on the map. This
enables you to review the route at a later time.
If you have previously recorded any trace
records these will be shown in the list. If there
are no trace records you will have to record
one first.
Recording a trace record: Use the
button to start the recording process. When
active this button will then change to show
. In this way the key will always show
the option which is currently not selected. It is recommended that you start recording after
your route has been planned or when you are in Free Navigation and you have a valid
GPS signal, and you should stop recording once you have reached your destination. This
will prevent the unit from continually recording while you are not driving and it will also
divide each journey into a separate trace record. Once you have started a trace recording
you will need to return back to the map screen.
Note: if you switch the unit off without stopping the trace record function then your trace
record for that journey will be lost.
Each recording will be logged with the following information.
Viewing a trace record: Select the trace record you want to view. The currently selected
trace record will be highlighted orange. Then use the
button to view the trace
Advertisement
Table of Contents
